Automotive Paint Protection

 

 

XPEL ULTIMATE Paint Protection Film


XPEL Paint Protection Products protect the leading edge of your vehicle from damage caused by rocks, gravel, salt or insects through the application of a thin and virtually invisible urethane paint protection film.





Frequently Asked Questions


Self Healing

"How does XPEL ULTIMATE Paint Protection Film heal itself?"

XPEL ULTIMATE Paint Protection Film uses a special polymer in its clear coat that flows even though it is cured. This allows the clear coat to find its natural level again after being disturbed on the surface.

"How deep a scratch will heal?"

The clear coat is designed to heal surface scratches and common swirl marks that occur during routine washing of the car. If the scratch penetrates through the film's clear coat, it will not heal.

"How long does it take for a scratch to heal?"

The time for a scratch to heal depends on the severity of the scratch and the ambient temperature. Minor scratches usually heal in one hour at room temperature (72°F). In warmer climates, healing time will be shorter. The healing process can be accelerated at any time by pouring hot water over the scratched area.

"How many times will the clear coat heal itself?"

With this technology, there is no limit to the number of times the clear coat can heal itself. As long as the clear coat is not penetrated it will heal over and over again.

"How long will the clear coat last?"

Depending on how the film is cared for, the clear coat can last indefinitely. Regular washing and waxing will keep the clear coat in top condition for years to come.



Stain & Chemical Resistance

"How does XPEL ULTIMATE Paint Protection Film resist staining?"

The clear coat on XPEL ULTIMATE has a very low surface energy, which makes it extremely difficult for organic compounds to stick to the film. Insects, bird droppings and environmental contaminants (which would normally cause yellowing) such as road oils, exhaust smoke and pollution can be removed during regular washing. An example of a similar technology would be Teflon, where a Teflon pan is easy to clean because nothing will stick to it.

"What if a stain does not come off the film during normal washing?"

If ordinary car wash or soap and water will not remove a stain, there are a variety products available to do the job. In most cases simple isopropyl rubbing alcohol will remove anything on the surface of the film. In cases of more severe staining, or where something has been left on the film for a long period of time, a sparing amount of lacquer thinner can be used. Bug and tar remover available at any auto parts store is also effective. If you are unsure about the use of any other chemical on the surface of the film, please contact XPEL Support at 800-447-9928 for assistance."



How to Care for the Film

"How is care of XPEL ULTIMATE different than other films?"

XPEL ULTIMATE Paint Protection Film requires less maintenance than any other brand of film on the market. Our general care instructions are:

·         Wait 48 hours after installation to wash your car

·         Remove insect or other stains with bug and tar remover

·         Stubborn stains can be removed with 99% isopropyl alcohol or lacquer thinner. Take care to keep these chemicals off the vehicle's paint

·         Seal with XPEL Flawless Finish Paint Protection Film Sealant at least once every 3 months to preserve high gloss

·         Light scratches in the film will self-heal in 20-30 minutes at room temperature. In colder conditions, or to accelerate the process, pour warm water (120°F) over the affected area

"Can I wax the film when I wax the rest of the car?"

Unlike most paint protection films on the market, XPEL ULTIMATE Paint Protection film can be waxed and sealed just like your paint. Though XPEL Flawless Finish Paint Protection Film Sealant is still the preferred product, Any automotive wax or sealant may be used.

"Will XPEL ULTIMATE make the paint underneath the film fade at a different rate?"

No. XPEL ULTIMATE Paint Protection Film allows UV to pass through the film and fade the paint underneath at the same rate as the exposed paint.



 Installation Differences

"Does XPEL ULTIMATE Paint Protection Film install the same way as other films?"

All paint protection films on the market install at least slightly different from one another. This is due to differences in adhesive chemistry, clear coat density, etc. XPEL ULTIMATE is an extremely installer friendly film when applied using XPEL's recommended installation guidelines.

"Can I stretch the film if it has an automotive clear-coat on top?"

XPEL ULTIMATE can be stretched just like any other paint protection film. The only difference that will be felt is that some extra force will be needed to stretch the film due to the greater density of the clear coat.


 

XPEL Clear Bra Paint Protection Products



A revolution in the automotive world

"Perhaps the best product you have never seen..." - Motor Trend Magazine

XPEL Paint Protection Products protect the leading edge of your vehicle from damage caused by rocks, gravel, salt or insects through the application of a thin and virtually invisible urethane film. All XPEL products are computer cut to ensure rapid and damage free installation. XPEL has developed a worldwide network of dealers factory trained in product application.

XPEL Paint Protection Film is a rugged eight mil (.008") clear Urethane plastic employing a clear-coat finish for maximum shine. This durable material has been used successfully for years by the military, various auto manufacturers, and NASCAR race teams in rock chip prone areas with incredible results.

 XPEL Headlight Protection

Never break an expensive headlight or fog light again!

With the average cost of replacement head lamps and fog lamps spiraling to nearly $300, it is nice to know that there is a product available to protect your car against the perils of the open road. Our Light Protection Products are made from a proprietary, scratch-resistant, urethane material coupled with the strongest optically clear adhesive available. Designed for maximum durability, our light covers were originally tested under the harshest of circumstances with amazing results. Both in the real world and in the lab, our covers have proven that they will withstand a barrage of 1" diameter stones (about 1oz.) at speeds up to 120 m.p.h. with no damage to the lens they protect. It is nice to know that your expensive lenses are protected in every scenario.

XPEL's Ultimate Paint Protection Film combines best-in-class durability and clarity not previously available in the market. With its very low surface energy, XPEL ULTIMATE sheds contaminants that would otherwise stain or yellow conventional films. In addition, the clear coat employs special elastomeric polymers that "heal" over time eliminating swirl marks and other fine scratches without having to do anything.


Watch a demostration of how XPEL Protective Film is installed.

Contact

Willis Auto Campus

2121 NW 100th Street
Directions Des Moines, IA 50325
Directions

  • Sales: 855-638-1176
  • Service: 855-638-1178
  • Parts: 855-638-1181

Make an Inquiry